HomeError CodesGE Monogram
12 Code Families Covered

GE Monogram Error Codes

A short code means something in the sealed system, sensors, or electronics needs attention. Find your code's family below.

Same-day service
Call (720) 575-8612

Monogram's built-in line reports faults through its control board rather than a separate service display, which means a code and a dead panel are often the same underlying failure. The families below group by subsystem for that reason.

F0/F1 Family (Control Board Runaway)
merges "f0-f1-control" + "f1-runaway-control"
F2
See page for details
F3
See page for details
F4
See page for details
F7
See page for details
Control Board Failure
merges "control-board-failure" + "control-board-fault"
Dishwasher Leak/Fill Fault
See page for details
Dishwasher Not Draining
See page for details
Gas Oven No Ignition
See page for details
No Power / Dead Unit
See page for details
Self-Clean Door Latch
See page for details
Thermistor Sensor Fault
See page for details
Don't see your code, or not sure what it means?
Read it to us over the phone — we'll tell you exactly what's wrong before we even schedule a visit.
Call (720) 575-8612

*Elite Appliance Repair Denver is an independent repair company. We are not affiliated with, authorized by, endorsed by or sponsored by Sub-Zero, Inc., Wolf Appliance, Inc., Viking Range, LLC, BSH Home Appliances (Thermador, Bosch, Gaggenau) or any other manufacturer named on this site, nor by any of their distributors. All brand names and trademarks are the property of their respective owners and are used here only to describe the appliances we service. We are not a factory service provider and specialize exclusively in out-of-warranty appliance repairs.

© 2026 Elite Appliance Repair Denver. All rights reserved.
600 17th St, Denver, CO 80202 · (720) 575-8612
Call (720) 575-8612